Regulators

For some servos such as Futaba servo models 9241, 9251, 9253, 9254, 9255, 9256 and other digital servos are not capable of handling 6V, please connect a 5.1V step-down voltage regulator to the rudder servo, or connect it between BEC (ex. RCE-B6X) and the receiver for all servos. It could avoid the servos overloading and damaged

Key Features

•Eliminates the need for a separate battery for the receiver and servos
Overview
Our Battery Eliminator Circuit is a little device that eliminates the need for a receiver and servo battery pack. It draws higher voltage from the motor batteries and drops it to a voltage level that is suitable for your receiver and servos. This is required in applications which draw high power for multiple servos or use more than 3S motor packs, as most ESCs with linear BECs are not designed for these applications.

Using linear design, input power: 2 cell Li-ion or Li-poly battery, features no interference to receiver. Features power switch and voltage indicating light for battery status, to remind users to avoid over discharge the receiver’s battery and out of control caused by low voltage. For some servos such as Futaba servo models 9241, 9251, 9253, 9254, 9255, 9256 and other digital servos are not capable of handling 6V, please connect a 5.1V step-down voltage regulator to the rudder servo, or connect it between BEC (ex. RCE-B6X) and the receiver for all servos. It could avoid the servos overloading and damaged.

The Castle PRO BEC is intended for use in larger RC cars, electric aircraft, and helis that have high power demands for their radio/servo systems. It is ideal for most electric helis 500-size and larger. It will also work well in larger electric powered RC aircraft and RC crawlers and Monster Trucks that have high-powered servos.

For some servos such as Futaba servo models 9241, 9251, 9253, 9254, 9255, 9256 and other digital servos are not capable of handling 6V, please connect a 5.1V step-down voltage regulator to the rudder servo, or connect it between BEC (ex. RCE-B6X) and the receiver for all servos. It could avoid the servos overloading and damaged

Works great with the ELY-Q Regulators
The Pin-Flag switch is a fail-safe-on type switch. If the switch is destroyed, the unit will remain ON. Only when the pin is inserted into the switch does the unit turn OFF.
Bight Blue LED activates when the switch is in the ON position

Separate outputs: 1 output at 5V (5Amps) dedicated specifically to RX, this guarantees a perfect current avoiding disturbs created by power services. The other output is related to power and it is subjected to be programmed. The output can be programmed up to 5V ­ 6V ­ 7.2V and in by ­ pass mode (current reaches directly the final output) and a formidable power capacity to support the ultimate generation high peak servos (from 10A to 100A).