Tools

Take the guesswork out of making holes! Easier than pencil, and more accurate than paper templates for pinpointing bolt holes, the pen-sized Hole Locator centres itself and its drill tip creates a starter hole in the engine mount to keep the bit on target. Simple and efficient.

The Compass Cutter allows you to cut circles in soft materials from 1~15mm diameter.

These affordable, high quality stainless steel shears feature a slightly curved cutting edge and are perfect for trimming car body shells, aircraft canopies, cowlings, etc.

This tool holds 2,3,4 pin flywheels and is used for 17mm wheel nuts

Taper Reamers offer an easy way to open or enlarge holes in plastics, softer woods and thin metal sheet, ideal for working on car body shells, etc! The fine point means that you don't have to pre-drill your hole either!

Quality Machined, Hard Anodised, Stepped Reamer Marked in MM & Inches

Superb quality carbon steel

Suitable for all Minicraft rotary tools & MB680 sensitive bench drill
Ideal for close up & detailed work
800mm long
Comes with 2.3mm collet and engraving sleeve
Will accept 3.2mm chuck

Super hard screwdriver head mady by high alloy steel,wear and distortion resisting!
Purifier handle made by aluminum alloy CNC , inside can place components and screws!
Using on heli's M2 socket screw and M3 socket screw!

1.5mm replacment tip for JP No. 4401600 and 4401625

2.0mm replacment tip for JP No. 4401600 and 4401625

For all 40 watt drills

The Dremel Multi cuts,sands,grinds,drills,sharpens,polioshes & more.works on all materials with speeds of 7500 -15000 RPM